BW Technologies GasAlert Micro5
 

BW Technologies PN: 
Unknown

BW Technologies Calibration Gas PN: CG-Q58-4

BW Technologies Calibration Gas:
25ppm Hydrogen Sulfide
100ppm Carbon Monoxide
50% LEL Methane
18.0% Oxygen
Nitrogen Balance



BW GasAlert Micro5 Calibration Guide:


Want to calibrate the BW GasAlert Micro5? Here's how:

  1. Turn the BW GasAlert Micro5 on in normal reading mode. Do this by pressing and holding the power button.
  2. Once the BW GasAlert Micro5 is in normal reading mode, you need to send it into calibration mode. Do this by pressing and holding the bottom left and right buttons at the same time. A count down will begin.
  3. This will send the monitor into zeroing mode. Now is a good time to set the monitor down, and grab your calibration gas, regulator, and calibration adapter.
  4. Open the valve on your regulator. This is a very important step so you do not ruin your calibration gas cylinder. Now screw it in to your calibration gas cylinder. Close the regulator once you hear gas spewing out of it. This is the signal to know your regulator is good to close. Continue screwing in the regulator until it stops. Do not overturn it.
  5. After the BW GasAlert Micro5 is zeroed, attach the tubing to the hose barb on your regulator. Make sure the tubing is also connected to your calibration adapter.
  6. Make sure your calibration gas values on the screen match what is on your calibration gas cylinder!
  7. Once the BW GasAlert Micro5 has finished calibration, the BW GasAlert Micro5 will beep, disconnect your tubing and turn off the gas.
  8. Congratulations! You have officially calibrated your BW GasAlert Micro5 gas monitor. Make sure to record these readings in your calibration log!

Helpful Part Numbers:

  • BW Technologies GasAlert Micro5 Replacement O2 Sensor - SR-X10-C1
  • BW Technologies GasAlert Micro5 Replacement LEL Sensor - SR-W04
  • BW Technologies GasAlert Micro5 Replacement CO Sensor - SR-M04-SC
  • BW Technologies GasAlert Micro5 Replacement H2S Sensor - PS-RH04S
  • BW Technologies GasAlert Micro5 Replacement PID Sensor (10.6 eV) - SR-Q07
  • BW Technologies GasAlert Micro5 Replacement NH3 Sensor - SR-A04
  • BW Technologies GasAlert Micro5 Replacement PH3 Sensor - SR-P04
  • BW Technologies GasAlert Micro5 Replacement ClO2 Sensor - SR-V04
  • BW Technologies GasAlert Micro5 Replacement SO2 Sensor - PS-RS04
  • BW Technologies GasAlert Micro5 Replacement Cl2 Sensor - PS-RC10
  • BW Technologies GasAlert Micro5 Replacement O3 Sensor - SR-G04